10.Or G Dead Boot Repair/Unbrick/ Flashing Firmware[8.1.0] Guide By GD_Mekail92

10.Or G Dead Boot Repair/Unbrick/ Flashing Firmware[8.1.0] Guide By GD_Mekail92

10.Or G Dead Boot Repair/Unbrick/ Flashing Firmware[8.1.0] Guide By GD_Mekail92

10.Or G Edl Test Point

10.or Flash Tool
HQXA_Transsion_CustomerDL_EMMC_V1.19.5

Firmware *New Link*

10.orG_V1_0_72_DCC by GD_Mekail92.rar

Flashing Guide
HQXA_Transsion_CustomerDL_EMMC_V1.19.5 Shared By GD_Mekail92

Click /Run -ets.startrun
Window Will Open On Key Tab Type = administrator
Press Okay

See Image For Reference

Now Click On Usb Tab On upper Left Side

Connect Device In Edl Mode [Switch Off the Device Hold Vol up + Vol Down And Plug Usb]

If Device Is Dead Or Making “Qualcomm HS-USB Diagnostics 900E ” Then Use Test Point, Picture Posted Above

After Connecting Check Usb Number And Remmember that

Now Click On SET And Select DL MOde=Emergency Mode NV Data Emergency Download Ver /Retain NV

Click On Change Path And Select The Firmware [Were You Have Been Saved]

Select The USB [Which You Saw On Previous Step]

Press Ok

See Image For Reference

After Click Okay Software verification Will Start-Wait Till It Finish
See Image For Reference

Check Tool Will SHow Device Connected And Ready
Click On Start ALL And Wait Till Flashing Get Completed
See Image For Reference

10.orG Password=GD_Mekail92 10.0R G Unbrick